公共场所火灾伤员转运护理应急资源评估

为保障伤员生命与健康,提升火灾伤员救治率,该文研究公共场所火灾伤员转运护理应急资源评估方法。以火灾伤员转运护理应急资源需求分析为基础,从应急人员、应急设备、应急环境信息与应急管理四个方面出发,共选取15个评估指标,构建公共场所火灾伤员转运护理应急资源评估指标体系,根据各指标采集相关数据并对数据实施量纲标准化处理。构建基于层次分析法的评估模型,计算评估指标体系内各指标权重,引入类间权重与类内权重两个变量,分别表示专家学术与经验差异和专家个体逻辑性差异,提升指标权重的合理性;通过综合模糊评价将各指标分为“差、较差、一般、较好、好”五个等级。以某隧道火灾为对象采用该方法评估,验证了本方法的有效性。     

太湖水土界面氮磷交换通量的时空差异

利用原柱样静态释放实验及间隙水分子扩散模型对太湖典型草型湖区(东太湖)及藻型湖区(梅梁湾)的氮磷释放通量进行了逐月研究.原柱样氮磷静态界面交换通量(F_i)在同一湖泊不同生态类型湖区有差异性,东太湖氨态氮和可溶性磷酸盐的年平均交换通量分别为(44.9±21.9)mg·(m²·d)^-1(平均值±标准偏差)和(2.06±1.71)mg·(m²·d)^-1,梅梁湾为(16.2±12.0)mg·(m^-1·d)^-1和(0.53±0.52)mg·(m²·d)^-1.2湖区的分子扩散通量(F_m)同样表现为这样的差异,但是其绝对值与静态释放通量相比有数量级的差异,该模型不能用于太湖这样风浪显著且底栖生物活性较高的湖泊水土界面氮磷营养盐交换通量的估算.仅从不同生态类型的湖区比较结果看,草型湖区比藻型湖区有更高的氮磷交换通量.F_i/F_m比值作为1种反映底栖生物活性的指标反映出东太湖有更高的底栖活性.在水体溶解氧水平通常保持在较高的水平,即好氧状态下,氮磷界面交换通量与溶解氧水平(DO)无显著相关.同样,在现有浓度水平下,其水土界面交换通量与水体氮磷浓度无显著相关.东太湖较高的释放通量与相对较低的水体营养盐负荷的差异来自于大型水生植被的消浪促沉降及其本身的吸附吸收作用,这是恢复水生植被以重建健康水生生态系统的重要理论依据.     

内置转盘式膜-生物反应器处理污水的工艺条件研究

对内置转盘式膜-生物反应器(SRMBR)处理污水工艺进行了研究.进水COD 160～368 mg/L时,出水COD在运行1d后降低到20 mg/L以下,去除率大于90%;转盘式膜组件的转速在0～25 r/min范围内,平衡膜通量随转速增大而快速增加,继续增大转速则平衡膜通量的增加变得不显著;在一定范围(0～1min)内延长停抽时间有助于缓解膜污染;SRMBR在较低的气水比(15∶1)下运行,也可达到较高的平衡膜通量.研究表明,SRMBR在最佳组合操作条件(转速为25r/min,抽/停为9min/1min,气水比为15∶1,抽吸压力为25kPa)下运行,其平衡膜通量高达53.75L/(m²·h).     

粉末活性炭预处理对超滤膜通量的影响

研究了粉末活性炭预处理对改善超滤膜过滤通量的效果.试验采用了4种具有不同亲疏水性的水样,着重探讨粉末活性炭对有机物的疏水性和亲水性组分的去除效果以及所带来的通量改善.试验结果表明,对于4种水样,超滤膜直接过滤原水时,通量下降严重.虽然粉末活性炭预处理能在一定程度上提高通量,但通量下降的趋势仍未改善.对有机物各组分的分析表明,直接过滤原水时,膜主要截留疏水性有机物;粉末炭吸附主要去除亲水性有机物,而超滤膜过滤粉末炭处理水时,主要截留疏水性有机物.由此,超滤膜的通量下降主要是由疏水性有机物引起的,亲水性组分对通量的影响较小.     

土壤二维蒸气抽排去污效果的影响研究

土壤蒸气抽排是一种经济、高效、安全并已被广泛应用的污染场址现场修复技术,它能经济高效地去除非饱和带土壤中的挥发性有机污染物。以土壤和油污染物为例,进行了土壤二维抽排模拟实验,研究了气体抽排流量对去污效果的影响,通过实验可知:在增加气体抽排流量的情况下,抽排气中挥发性较强的有机物质正戊烷(C5h12)浓度下降的很快,最终保存在较低的浓度水平。挥发性一般的正辛烷(C8h18)和挥发性较弱的正癸烷(C10h22)经过长时间的抽排后,污染物也得到了降低,但是最终保持在比较高的浓度水平。得出增加气体抽排流量可以使污染物去除速率大幅度提高,从而缩短了净化时间,获得很好的去污效果。同时对二维抽排模拟实验和一维抽排模拟实验结果做了比较。     

石油生物脱硫技术研究进展

生物脱硫技术由于具有条件温和、能耗低等优势受到人们关注。对生物脱硫新型微生物的筛选方向、生物脱硫技术中脱硫菌生长以及脱硫限制、传质限制等因素及其近期研究进展等方面进行了介绍,以期促进生物脱硫技术的研究深度。     

农地流转背景下地块规模对农户种粮投入影响分析

近年来粮食安全受到国家和社会的广泛关注,农地投入作为粮食生产的重要要素,是保障粮食稳定产出的前提。学者就农地规模对农户种粮投入的影响已进行了较多研究,但受农地流转的影响,土地要素更具多样化,土地规模与农户种粮投入的关系发生变化。随着农地流转在我国的快速发展,探析农地流转影响下土地规模对农户种粮投入影响的变化成为一个亟待研究的问题,对保障国家粮食安全具有重要意义。考虑到地块的异质性,本文基于山东、河南、安徽三个粮食主产省622户农户1 284个地块的粮食生产数据从村庄和农户两个层次控制了生产要素市场价格、地块要素等非主观因素,进行多层模型回归分析。结果表明,农地流转特征及地块特征对农户粮食生产单位面积投入有显著影响。地块规模和转入地占比对农地投入影响为负,转入地占比越大,地权稳定性越低,农户投入积极性受到挫伤越明显,在转入地上的投入减少。随着转入土地面积的增加,农户从事粮食生产的机会成本增大,使其有更强的动力增加种粮投入,地块规模的负向影响程度降低。基于分析结果,本文得出以下3点结论:(1)规模化经营有利于降低单位面积种粮成本;(2)农地流转发生时,地块规模对种粮投入的影响发生改变,成片规模化经营将成为我国粮食生产的必然趋势;(3)提高土地综合条件可以降低投入成本,并提高农户投入积极性。要保障国家粮食安全,需从降低种粮成本、提高农户收益着手,建议鼓励农村土地流转,推动粮食规模化生产,同时也要注重增加财政拨款,建设高标准粮田,强化高标准粮田的农业基础设施建设,完善田间配套工程。     

Insights into the electron transfer mechanisms of permanganate activation by carbon nanotube membrane for enhanced micropollutants degradation

● A CNT filter enabled effective KMnO₄ activation via facilitated electron transfer. ● Ultra-fast degradation of micropollutants were achieved in KMnO₄/CNT system. ● CNT mediated electron transfer process from electron-rich molecules to KMnO₄. ● Electron transfer dominated organic degradation. Numerous reagents have been proposed as electron sacrificers to induce the decomposition of permanganate (KMnO₄) by producing highly reactive Mn species for micropollutants degradation. However, this strategy can lead to low KMnO₄ utilization efficiency due to limitations associated with poor mass transport and high energy consumption. In the present study, we rationally designed a catalytic carbon nanotube (CNT) membrane for KMnO₄ activation toward enhanced degradation of micropollutants. The proposed flow-through system outperformed conventional batch reactor owing to the improved mass transfer via convection. Under optimal conditionals, a > 70% removal (equivalent to an oxidation flux of 2.43 mmol/(h·m²)) of 80 μmol/L sulfamethoxazole (SMX) solution can be achieved at single-pass mode. The experimental analysis and DFT studies verified that CNT could mediate direct electron transfer from organic molecules to KMnO₄, resulting in a high utilization efficiency of KMnO₄. Furthermore, the KMnO₄/CNT system had outstanding reusability and CNT could maintain a long-lasting reactivity, which served as a green strategy for the remediation of micropollutants in a sustainable manner. This study provides new insights into the electron transfer mechanisms and unveils the advantages of effective KMnO₄ utilization in the KMnO₄/CNT system for environmental remediation.     

Development of heat transfer and evaporation model of LNG covered by Hi-Ex foam

Natural gas is a kind of clean, efficient green energy source, which is used widely. Liquefied natural gas (LNG) is produced by cooling natural gas to −161 °C, at which it becomes the liquid. Once LNG was released, fire or explosion would happen when ignition source existed nearby. The high expansion foam (Hi-Ex foam) is believed to quickly blanket on the top of LNG spillage pool and warm the LNG vapor to lower the vapor cloud density at the ground level and raising vapor buoyancy. To identify the physical structure after it contacted with LN₂ and to develop heat transfer model, the small-scale field test with liquid nitrogen (LN₂) was designed. In experiment, three layers including frozen ice layer, frozen Hi-Ex layer and soft layer of Hi-Ex foam were observed at the steady state. By characterizing physical structure of the foam, formulas for calculating the surface of single foam bubble and counting foam film thickness were deduced. The micro heat transfer and evaporation model between cryogenic liquid and Hi-Ex foam was established. Indicating the physical structure of the frozen ice layer, there were a certain number of icicles below it. The heat transfer and evaporation mathematical model between the frozen ice layer and LNG was derived. Combining models above with the heat transfer between LNG, ground and cofferdam, the heat transfer and evaporation mathematical model of LNG covered by Hi-Ex foam was developed eventually. Finally, LN₂ evaporation rate calculated by this model was compared with the measured evaporation rate. The calculated results are 1.2–2.1 times of experimental results, which were acceptable in engineering and proved the model was reliable.     

Study of the performance of a coolant mixed with an Al2O3/SiC nanomaterial in an engine radiator

One of the important components of a car to control the temperature of a car's engine is the radiator. To increase the heat absorption capacity of the coolant/fluid used in the radiator with minimum pumping power, innovative fluids called nanofluids have become the main area of research these days. Therefore, with the development of new technologies in the field of “nano-materials” and “nano-fluids,” the physical and chemical properties of coolant/fluid can be improved which in turn improves the radiator and engine efficiency, and reduces radiator weight and size. In this article, the heat transfer by forced convection in nanofluids based on Al₂O₃ and SiC was studied experimentally and compared to that of base fluid in an automotive radiator. The nanofluid is mixed with ethylene glycol and the fluid is prepared by the sonication method. The nanofluids were prepared by varying the nanomaterials and the amounts of nanomaterials in the base fluid and their heat transfer performance in the radiator was analyzed using ANSYS FLUENT software. Approximately 15% and 12% increase in radiator efficiency by using Al₂O₃ mixed nanofluid and SiC mixed nanofluid, respectively.